My commuter bike broke down about two weeks ago, so I bought a new chain. But, new chain and worn out sprockets are not a good combination. So after advice from Espen I decided to buy the Single Speed Conversion Kit. In that way I will reduce the need for maintenance and hopefully over time reduced cost as well 🙂 Tomorrow I have planned to try it out, hopefully doing 50 kilometers or so.
In addition to the kit I had to buy a new dropout since the internal threads in the old one was long gone. I also had to buy a new KMC 8 chain. The old one was a 9’er, and worn out in just a week because of the old sprockets, but normally you need no more than the kit to convert your bike.
Sexy driveline?
Notice that I use the tension seeker downwards, not upwards. It is recommended to use it upwards, but since I could not cut the KMC-chain just one link, but needed to cut two it would get to tight. Therefore downwards.







